SPONSORED LINKS

1975 Chevy Corvette

Tiny
CRX1493
  • MEMBER
  • 1975 CHEVROLET CORVETTE
Engine Performance problem
1975 Chevy Corvette V8 Two Wheel Drive Manual n/a miles

just replaced a intake manifold on 75 corvette chevy 350 and now car won't start think buddy got junk down ports when intake was off reset distributor at top dead center and cleaned plugs they had fluid and chunks of gunk on them and car still won't start don't know what would be best way to get gunk out of cylinders
SPONSORED LINKS
Monday, March 1st, 2010 AT 4:59 AM

1 Reply

Tiny
VEGASMSTRJ
  • MEMBER
  • 50 POSTS
I don't think its gunk in the engine. It would still start and run a little rough til it got cleaned out. It might be an electrical problem. Maybe the wires that go into the distributor or something along those lines.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Tuesday, March 16th, 2010 AT 9:42 PM

Please login or register to post a reply.

Related Intake Manifold Replace/Remove Content

Intake Manifold Replace
VIDEO
Intake Manifold Replace
Instructional repair video
Intake Manifold Replacement
GUIDE
Intake Manifold Replacement
When an intake gasket or intake manifold fails it can create a vacuum or coolant leak which will cause the engine to run poorly or overheat. This can happen over time, if...
VIEW MORE

Sponsored links