1997 k2500 4x4 Misfire

1997 CHEVROLET CHEYENNE
Avatar
ROBBIET87
  • MEMBER
  • 4 POSTS
Hi guys,
I have a 1997 Chevrolet k2500 4x4 with a vortec 350.It seems to have a noticeable snap in what sounds like the distributor at higher rpm levels.I pulled plug wires off and the number 6 plug wire that runs to distributor cap was corroded white.So I replaced with a used one I had laying around and it seemed to fix it, for awhile.Now it is doing it again.I switched wire around 2 months ago and it started missing about a week after.This is getting kind of frustrating!!!Any help would be very much appreciated.Thanks
Jun 26, 2007 at 11:16 PM
Advertisement
Avatar
CESAR LOMELI
  • MEMBER
  • 30 POSTS
change your wires and make sure the fireing order is correct also check your cap and rotor for corossion and replace as needed same goes for your spark plugs






good luck
Jan 22, 2008 at 12:11 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.