I had to change a dead battery. I know by disconnecting the battery the computer probably eeds reprogramed. Can I do this and how?
Apr 24, 2010 at 9:41 AM
1987 Chevy Celebrity reprogram
GSTST4
- MEMBER
- 3 POSTS
Computer relearning process-
Automatic Transmission
Set parking brake, start engine in "P" or "N" position. Warm-up vehicle to normal operating temperature or until cooling fan cycles.
Allow vehicle to idle for one minute in "N" position. Select "D" and allow engine to idle for one minute.
Accelerate at normal throttle position (20-50%) until vehicle shifts into top gear.
Cruise at light to medium throttle.
Decelerate to a stop, allowing vehicle to downshift, and use brakes normally.
Process may be repeated as necessary.
Automatic Transmission
Set parking brake, start engine in "P" or "N" position. Warm-up vehicle to normal operating temperature or until cooling fan cycles.
Allow vehicle to idle for one minute in "N" position. Select "D" and allow engine to idle for one minute.
Accelerate at normal throttle position (20-50%) until vehicle shifts into top gear.
Cruise at light to medium throttle.
Decelerate to a stop, allowing vehicle to downshift, and use brakes normally.
Process may be repeated as necessary.
Apr 24, 2010 at 3:25 PM
The problem is the car will not start since disconnecting the battery and putting a new one in. It turns over, but no slight indication of starting.
Apr 25, 2010 at 5:19 AM
No cranking could mean starter, park and neutral switch and ignitiion switch-double check battery and connection
Apr 25, 2010 at 9:09 AM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement
parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.