Change to a new battery interstate

2006 CHRYSLER CROSSFIRE
65,000 MILES • 6 CYL • 2WD • AUTOMATIC
Avatar
GRENFROGS
  • MEMBER
  • 1 POST
Is there anything I need to do different I am putting a new battery in the crossfire. Pos then neg and then start the car any buttons I need to push or does it need to be programmed for this new battery, thank you for your time
Mar 5, 2014 at 10:21 PM
Advertisement
Avatar
HMAC300
  • ✓ASE Certified Mechanic
  • 48,601 POSTS
  • ASE Certified Mechanic
you may have to reset the security system if yo have it due to disconnecting the battery if no manual look onine on how to do it.
Mar 6, 2014 at 5:43 AM
Avatar
HOMER1967
  • ✓ASE Certified Mechanic
  • 875 POSTS
  • ASE Certified Mechanic
the car will probably run rough stall at first,but that is normal.just keep it running for about ten minutes or drive it a few miles if you can and it will re-learn on it's own.as far as the battery is concerned you ALWAYS remove the positive cable first and hook it back up last.
Mar 6, 2014 at 8:02 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.