Car not starting

2009 NISSAN 240Z
12,500 MILES • 3.0L • 4 CYL • 4WD • AUTOMATIC
Avatar
BRIANMAKOSA
  • MEMBER
  • 1 POST
I have Isuzu como with a ZD30 COMMON RAIL which is not starting on OBD 2 Machine we are getting this fault code p0341 Camshart Position Sensor A Ciruit
Bank 1 or Single Sensor
Sep 15, 2019 at 10:53 AM
Avatar
MASTERWRENCH
  • ✓Experienced Mechanic
  • 258 POSTS
Welcome to 2CarPros!

P0341 is a generic OBD II code and basically means that the PCM is not receiving a valid signal from the camshaft position sensor. I would start by inspecting the wiring from the sensor back to the PCM connector. Pay close attention to areas where the harness makes hard turns around engine mounts or components. These are typically areas were wires will begin to rub through, causing a short to ground. If you don't find any wiring issues, there's a good chance the code is the result of a failed sensor.

Let us know what you find!
Sep 17, 2019 at 3:09 PM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Ask a new question

Frequently Asked Problems for This Vehicle