I dont know where the camshaft positioning sensor is located. I had it diagnosed today but dont know where it is to change it.
Apr 24, 2013 at 8:26 AM
canshaft positioning sensor
2007 JEEP COMPASS
CHYSSY
- MEMBER
- 1 POST
- FOLLOW
Advertisement
The camshaft position sensor is at the rear of the engine on the cylinder head. Here is a guide and the diagrams below so you can see how the job is done.
https://www.2carpros.com/articles/camshaft-angle-sensor-replacement
Check out the diagrams (Below). Please let us know if you need anything else to get the problem fixed.
https://www.2carpros.com/articles/camshaft-angle-sensor-replacement
Check out the diagrams (Below). Please let us know if you need anything else to get the problem fixed.
Image (Click to enlarge)
Apr 24, 2013 at 8:41 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.