cannot shift gears

2008 SCION TC
130,000 MILES • 2.4L • 4 CYL • 2WD • MANUAL
Avatar
HENRYD316
  • MEMBER
  • 2 POSTS
cannot shift gears without slight grinding after putting in first gear and at takeoff grinding noise continues so I have not used vehicle since. I checked the brake fluid, level is okay. I checked the slave cylinder for leaks, no leaks, bled the slave cylinder slightly less grinding noise, but I still cannot shift without grinding, Is there anything else I should check before changing the clutch?
May 31, 2016 at 12:36 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • ✓ASE Certified Mechanic
  • 110,193 POSTS
  • ASE Certified Mechanic
If it is hard to shift into gear when running, check to see if it is easier with the engine off, If it shifts easily off, the clutch isn't fully disengaging. This is most likely the result of a weak slave or clutch MC.
May 31, 2016 at 8:46 PM
Avatar
HENRYD316
  • MEMBER
  • 2 POSTS
Thank You very much for taking the time to answer my question
Jun 10, 2016 at 11:26 AM
Avatar
STRAILER
  • ✓ASE Certified Mechanic
  • 54,832 POSTS
  • ASE Certified Mechanic
This can also be caused by the clutch disc lining falling apart while will not allow the clutch to disengage as well. Please let us know what you find.

Best, Ken
Jun 11, 2016 at 5:18 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.