Engine will not stay running and Cam sensor reading is zero

2009 GMC ACADIA
160,000 MILES • 3.6L • 6 CYL • 2WD • AUTOMATIC
Avatar
DAN MARTINDALE
  • MEMBER
  • 4 POSTS
I've been having trouble with my vehicle starting and then immediately stalling. When i do a live scan i notice that the cam sensors are all doing counts, but it shows cam sensor RPM at zero. I think the problem may be there which is probably affecting timing.

What is the most logical cause of this? I am getting zero codes but show a very lean mixture of 29.3:1 command ratio and about a .9 equivalence ratio. Thanks for your time.
Jan 6, 2022 at 1:06 AM
Avatar
JACOBANDNICKOLAS
  • ✓Experienced Mechanic
  • 110,246 POSTS
Hi,

The idea that it is running lean can be the result of low fuel pressure or an engine vacuum leak. Have you checked either of those at this point?

https://www.2carpros.com/articles/how-to-check-fuel-system-pressure-and-regulator

https://www.2carpros.com/articles/how-to-use-an-engine-vacuum-gauge

Also, did you check for a crankshaft positions sensor signal? That can prevent an RPM signal. However, I wouldn't even think it would start without either providing a signal.

Let me know.

Joe
Jan 6, 2022 at 9:19 AM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Ask a new question

Frequently Asked Problems for This Vehicle