broken part secondary air injection solenoid?

2000 TOYOTA CAMRY SOLARA
147,000 MILES • 2.2L • 4 CYL • AUTOMATIC
Avatar
JOE1953
  • MEMBER
  • 781 POSTS
What can i use to glue a broken piece back on to a secondary air injection solenoid? i broke the nipple of where the vacuum hose connects to.
Dec 27, 2024 at 2:12 PM
Advertisement
Avatar
STRAILER
  • CAR REPAIR CONTRIBUTOR
  • 54,354 POSTS
Not usually, the glue ends up plugging the vacuum hole to the solenoid, but if you upload an image of the part in question I can tell for sure.
Dec 28, 2024 at 11:07 AM
Avatar
JOE1953
  • MEMBER
  • 781 POSTS
I don't know how to upload an image of the part.
Dec 28, 2024 at 4:21 PM
Avatar
STRAILER
  • CAR REPAIR CONTRIBUTOR
  • 54,354 POSTS
Take an image with your phone and upload it here with your response.
Dec 29, 2024 at 12:51 PM
Avatar
JOE1953
  • MEMBER
  • 781 POSTS
I can take an image with my phone but i can't upload it with it i have a flip phone. I am using a laptop computer.
Dec 29, 2024 at 1:08 PM
Avatar
STRAILER
  • CAR REPAIR CONTRIBUTOR
  • 54,354 POSTS
Okay, if you can glue it without it blocking the vacuum hole you should be good as long as it doesn't break, if it breaks again you will need to replace it.
Dec 30, 2024 at 9:08 AM
Avatar
JOE1953
  • MEMBER
  • 781 POSTS
I want to know what kind of glue to use?
Dec 30, 2024 at 9:30 AM
Avatar
STRAILER
  • CAR REPAIR CONTRIBUTOR
  • 54,354 POSTS
I would try JB weld.
Dec 30, 2024 at 10:18 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.