Brakes pedal goes to the floor

2010 FORD FUSION
150,000 MILES • 2.5L • 4 CYL • 2WD • AUTOMATIC
Avatar
GRAVEL
  • MEMBER
  • 1 POST
My brake pads were metal to metal so i replace the rotor and pads. Bled the brakes and had a pedal but it slowly goes to the floor. So, went through the calipers and the rear calipers were bad. Replace them now the brakes will not bleed i have no pedal.
Dec 10, 2021 at 5:33 AM
Advertisement
Avatar
ASEMASTER6371
  • ✓ASE Certified Mechanic
  • 52,796 POSTS
  • ASE Certified Mechanic
Good morning,

This sounds like you have a bad master cylinder as that is where the pressure is produced for the system.

https://www.2carpros.com/articles/brake-pedal-goes-to-the-floor

I attached the procedure for replacing the master cylinder.

https://www.2carpros.com/articles/how-to-replace-a-brake-master-cylinder

https://www.2carpros.com/articles/how-to-bleed-or-flush-a-car-brake-system

Roy

Images (Click to enlarge)
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Dec 10, 2021 at 7:11 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.