Brakes locking up

2003 HONDA ODYSSEY
280,000 MILES • 6 CYL • 2WD • AUTOMATIC
Avatar
BRIANGILLEN
  • MEMBER
  • 1 POST
I just replaced the master cylinder because it had on brake pedal.

Now the brakes are locking up after I drive it for a while. If I remove the vacuum line from the brake booster it releases the pressure and unlocks the brakes. Obviously, I’d like a more convenient solution!

Any guidance anyone can give me about what’s going on and how to fix it would be appreciated.

Thanks, Brian.
Jan 3, 2022 at 4:35 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
KASEKENNY
  • CAR REPAIR CONTRIBUTOR
  • 18,907 POSTS
Assuming this was not happening prior, I suspect you have a faulty master cylinder.

More than likely what is happening is the master is getting stuck and when you remove the vacuum booster it is releasing the pedal.

You may get the same result if you pick up on the pedal.

https://www.2carpros.com/articles/how-to-replace-a-brake-master-cylinder

However, I can't get a good picture of the pedal assembly because it may not pull the pedal back. It may rely on master cylinder negative pressure which means the master is what returns the pedal. However, if it is getting stuck then it will not do this.

Basically, if this just started after replacing the master cylinder, I would suggest replacing it again as the parts store should exchange it for you.
Image (Click to enlarge)
Attached Media
Jan 4, 2022 at 12:18 PM
Advertisement