Brake pedal traveling to floor before and after master cylinder replacement?

2005 FORD E-SERIES VAN
72,500 MILES • 2.6L • V8 • 2WD • AUTOMATIC
Avatar
DUSTYURNOT…
  • MEMBER
  • 1 POST
Replaced master brake cylinder all brake pads replaced, totally bleed system (x2, 2 quarts of fluid used) starting with rear right, r/l, f/r, f/l. No fluid leaks anywhere.
ABS dash light is not illuminated except for engine start up. ABS light does not illuminate when braking. Both low (5A) fuse and high (60A) fuses for ABS system tested good, removed and cleaned fuse contact blades to make sure conductivity was positive.
Is the ABS pump motor defective?
Am I missing something?
Is there a test procedure for the pump motor?
Nov 8, 2022 at 12:10 AM
Avatar
STRAILER
  • ✓Experienced Mechanic
  • 55,676 POSTS
Sure, so what happens is the ABS unit gets air trapped inside which causes the brake pedal to be low or to go to the floor. The ABS unit needs to be bled which requires the ABS control valves to be opened at the time of bleeding.

Here is a video and guide to help you fix the problem:

https://youtu.be/nQRnKyVyMuQ

and

https://www.2carpros.com/articles/brake-pedal-goes-to-the-floor

Let us know what happens and please upload pictures or videos of the problem.
Nov 8, 2022 at 1:28 AM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Ask a new question

Frequently Asked Problems for This Vehicle