bleeding air off my clutch

1996 TOYOTA
100,000 MILES • 3.0L • 4 CYL • 2WD • MANUAL
Avatar
VICTORY FARM
  • MEMBER
  • 5 POSTS
Hi please help, I took the bleed screw off the clutch slave cyinder and about 200ml brake fluid came out ,the screw was blocked.how do i bleed the air out of the system now
Jan 29, 2016 at 6:25 PM
Advertisement
Avatar
HMAC300
  • ✓Experienced Mechanic
  • 48,601 POSTS
remove the screw and clean the screw out thee is a hole on side bottom and top, they occasionally get junk in it.
Jan 29, 2016 at 10:20 PM
Avatar
VICTORY FARM
  • MEMBER
  • 5 POSTS
Many thank Boss but were do you bleed the fluid out of my toyota dyna and is there a second container to but fluid in?
Jan 30, 2016 at 12:42 AM
Avatar
HMAC300
  • ✓Experienced Mechanic
  • 48,601 POSTS
you have to bleed it like a brake system fill the master cylinder then go to the slave and open the bleed screw let it gravity drain first. never let the master cylinder empty while bleeding
Jan 30, 2016 at 1:33 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.