98 ranger driveshaft question

1998 ALL OTHER MAKES ALL OTHER MODELS
Avatar
RAYHUT
  • ✓ASE Certified Mechanic
  • ASE Certified Mechanic
  • 134 POSTS
this might sound like a dumb question but what is the round cylinder that is on the driveshaft it's between the transmission tail and the driveshaft.and will it be alright to remove becouse it has broken loose.
Mar 10, 2006 at 7:32 AM
Advertisement
Avatar
PEPPERMRJ
  • ✓ASE Certified Mechanic
  • 1,158 POSTS
  • ASE Certified Mechanic
Not sure I follow you. Is the driveshaft disconnected from the trans? Sounds like you broke a U joint. The yoke has a splined cylinder that slides into the tail of the tranny. Remove it and unbolt the driveshaft from the rear end. Have a new u-joint installed and reinstall the drive shaft, front first.

Good luck. :) Hope this helps.
Mar 11, 2006 at 7:36 PM
Avatar
RAYHUT
  • ✓ASE Certified Mechanic
  • 134 POSTS
  • ASE Certified Mechanic
it's not the u-joint, it's some kind of safty device i think.but it's bugging the hell out of me becouse it rattles and sometimes it gets caught up around my driveshaft and makes my truck shake going down the road.
Mar 13, 2006 at 3:38 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.