Advertisement

1990 integra overheating

Avatar
ALG369
  • MEMBER
  • 1 POST
my car keeps overheating after i replace the termostat,water pump, headgaskets, radiator, temperature censor. every time the temperature goes up to 3/4 the fan comes on and it goes back down but then it goes up again. it also goes down every time the revolutions go up to 3000 rpm
Nov 9, 2007 at 8:26 AM
Advertisement
Avatar
RASMATAZ
  • ✓Experienced Mechanic
  • 75,988 POSTS
Try this before you blow the gasket again

BLEEDING COOLING SYSTEM:

Always bleed air from cooling system after replacing coolant. Set heater for maximum heat. Remove radiator cap. Loosen drain plug and remove drain bolt (if equipped) from engine block. Drain coolant reservoir. Fill coolant reservoir to MAX mark with 50/50 water-coolant mixture. Loosen bleed bolt and fill radiator up to base of filler neck. Close bleed bolt when coolant flows out without bubbles. Tighten bleed bolt. With radiator cap removed, start and operate engine to normal operating temperature. Add coolant if necessary and check for leaks.
Nov 9, 2007 at 8:32 AM
Advertisement
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle

Advertisement