After changing both wheel assembly hubs on both sides the ABS stabilator and all-wheel drive off lights are still on. how do I get them off?
Dec 3, 2022 at 7:09 PM
ABS stabilator and AWD off the lights illuminated?
2011 CHEVROLET EQUINOX
CALVIN WIDEMAN
- MEMBER
- 19 POSTS
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
Hi,
As I believe you are aware, for all of these to turn on, it is likely you have a bad wheel speed sensor. Have you checked the ones that were not replaced?
If not, I would check to see if there is a signal from them. You can check them with a voltmeter or multimeter.
Here is a link that explains how it's done:
https://www.2carpros.com/articles/abs-wheel-speed-sensor-test
On the other hand, if you have a live data scan tool, you can drive the vehicle with it connected and check for speed signals from all sensors. If one is off or not working, that is where the problem is.
Let me know if you are comfortable performing the above test.
Take care,
Joe
As I believe you are aware, for all of these to turn on, it is likely you have a bad wheel speed sensor. Have you checked the ones that were not replaced?
If not, I would check to see if there is a signal from them. You can check them with a voltmeter or multimeter.
Here is a link that explains how it's done:
https://www.2carpros.com/articles/abs-wheel-speed-sensor-test
On the other hand, if you have a live data scan tool, you can drive the vehicle with it connected and check for speed signals from all sensors. If one is off or not working, that is where the problem is.
Let me know if you are comfortable performing the above test.
Take care,
Joe
Dec 4, 2022 at 6:25 PM
Advertisement