A/C compressor control valve, no cold air?

Okay, so when you drained the system did you leave in the oil and just drain the gas pressure because commonly Sometimes when people drain the system, they only drain the gas pressure and not the oil itself. Then when they go to refill it they fill it with the type of bottle that comes with oil mixed in with gas then they wind up with too much oil which can damage the system sometimes or at least cause it not to function normally. If there’s too much oil the pressure valve may not function properly obstructing the refrigerant from flowing through the system properly, so i always drain it completely of all oil and gas using a vacuum pump evacuation system and then refill it starting with negative 30 PSI pressure. Hope this helps, good luck.

If you’re sure the oil is the correct amount and the pressure is correct then while you’re looking you might want to test the wire connector at the pressure valve on the pump and if that checks out okay, then the pump itself or the TCM might be the problem. It’s hard to say but start with the simplest things first; like the oil level most systems only take a few ounces and it’s easy to go over the limit and create excess pressure. I’ve seen it damage pumps. Good luck