98 lumina air comes thru defrost only and fans won't turn on

1998 CHEVROLET LUMINA
175,000 MILES
Avatar
DENTALJENTX
  • MEMBER
  • 1 POST
1998 chevy lumina 3.1
after replacing battery my car is now running hot, but if i turn on the heat it seems to fix problem, but heat and air only coming thru defrost vents, also the big fans by radiator are not coming on....ever....The overheating prob worse in stop and go city traffic, my guess is on the frwy, the car gets enough air flowing thru it, but I usually leave the heat on 1 anyway, if the temp gauge goes up i turn heater up. scared cuz Tx summer is coming and i'm going to bake if problem isn't fixed.

looked for obvious wear.....hoses etc, have recently replaced serpentine belt, harmonic balancer, then tensioner pulley, that was cuz car kept dying and when i was jumping it I noticed the serpentine belt was chewed up which led to other parts being replaced, never addressed battery dying all the time, but figured out the ignition switch is hinky and must be 'just so' or i get like a parasitic drain....

the fans won't turn on no matter what.....
Apr 27, 2013 at 10:20 AM
Advertisement
Avatar
JDL
  • ASE Certified Mechanic
  • 16,098 POSTS
  • ASE Certified Mechanic
Does radiator fan/s run if you turn on ac? If you unplug the coolant temp sensor will the radiator fan run? Did you check voltage and ground at fan connector?
Apr 27, 2013 at 12:23 PM
Avatar
JDL
  • ASE Certified Mechanic
  • 16,098 POSTS
  • ASE Certified Mechanic
Check applicable fuses. Not only checxk the fuse, check for voltage on fuse circuit.
Apr 27, 2013 at 12:29 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.