Advertisement

Stalls at stop

200,000 MILES • 2.3L • 4 CYL • 2WD • MANUAL
Avatar
PHREDTOON
  • MEMBER
  • 3 POSTS
I pulled up to a red light turned green and my truck stalled and wouldn't start until I stabbed the gas pedal when turning it over. It idles a little rough. It stops shaking if I push the gas a little bit. I know it's not much to go on but would appreciate some help.
Jan 9, 2019 at 3:48 PM
Advertisement
Avatar
ASEMASTER6371
  • ✓Experienced Mechanic
  • 52,796 POSTS
Good morning,

There is an idle air control motor that controls the idle speed. You need to check and see if it is working.

I will attach a picture for you to view. It is a very common failure for this issue.

REMOVAL

1. Disconnect Idle Air Control (IAC) valve electrical connector.

2. Remove two IAC valve retaining screws.

3. Remove IAC valve and gasket.

NOTE: If scraping is necessary, be careful not to damage IAC valve or throttle body gasket surfaces, or drop material into throttle body.

4. Clean gasket surfaces.

INSTALLATION

1. Make sure that both throttle body and IAC valve gasket surfaces are clean.

2. Install IAC gasket on throttle body surface and mount IAC valve, securing it with two retaining screws. Tighten to 8-11 Nm (71-97 in lb).

3. Connect electrical connector to IAC valve.

Roy
Jan 9, 2019 at 10:10 PM
Advertisement
Avatar
PHREDTOON
  • MEMBER
  • 3 POSTS
I will give this a try and get back to you.
Jan 9, 2019 at 10:17 PM
Avatar
ASEMASTER6371
  • ✓Experienced Mechanic
  • 52,796 POSTS
Sounds like a plan.

Roy
Jan 9, 2019 at 10:20 PM
Advertisement
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle

Advertisement