It try’s to start but won’t. I replaced the crank sensor and plugs.
Jul 20, 2020 at 8:42 PM
Will not start
1989 CHEVROLET BERETTA
DANIEL SYLVIA ADAMS
- MEMBER
- 1 POST
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
Good morning,
Can you do some basic checks?
https://www.2carpros.com/articles/car-cranks-but-wont-start
You need fuel pressure,spark and compression for the engine to run.
https://www.2carpros.com/articles/how-to-check-fuel-system-pressure-and-regulator
https://www.2carpros.com/articles/how-to-test-an-ignition-system
https://www.2carpros.com/articles/how-to-test-engine-compression
You can rent a testers at a parts store for the compression and fuel pressure checks.
We need to start at basics.
Roy
Can you do some basic checks?
https://www.2carpros.com/articles/car-cranks-but-wont-start
You need fuel pressure,spark and compression for the engine to run.
https://www.2carpros.com/articles/how-to-check-fuel-system-pressure-and-regulator
https://www.2carpros.com/articles/how-to-test-an-ignition-system
https://www.2carpros.com/articles/how-to-test-engine-compression
You can rent a testers at a parts store for the compression and fuel pressure checks.
We need to start at basics.
Roy
Jul 21, 2020 at 4:36 AM
Advertisement