4wd will not work

2003 FORD RANGER
93,000 MILES • 4.0L • V6 • 4WD • MANUAL
Avatar
KAYDEN KIMMEL
  • MEMBER
  • 2 POSTS
Just put in a new 4x4 control module and transfer case motor in my truck listed above xlt. my light is now showing 4wd low but i am stuck in two wheel drive. Before i put in the new module and motor i was stuck in 4wd low with out the 4wd light on and when i installed the parts i am now stuck in 2wd with my light showing 4wd low.
Mar 9, 2019 at 7:12 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
ASEMASTER6371
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 52,796 POSTS
Good morning,

Are there any codes set for the system? You may need a scan tool that can read the 4X4 system. Normal code readers may not pick it up.

If you remove the motor from the transfer case, turn the key on, change commands for two and four wheel and see if the motor turns.

Check all the fuses I attached for power on both sides with the key on.



Roy
Images (Click to enlarge)
Attached Media
Attached Media
Mar 10, 2019 at 5:39 AM
Advertisement
Avatar
KAYDEN KIMMEL
  • MEMBER
  • 2 POSTS
Thank you. I will look into it and I will get back to you.
Mar 11, 2019 at 5:39 PM
Avatar
ASEMASTER6371
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 52,796 POSTS
You're welcome.

Always glad to help.

Roy
Mar 11, 2019 at 5:43 PM