Third cylinder missing until RPM’s raised

100,000 MILES • 4 CYL • 2WD • MANUAL
Avatar
TONYNEAL
  • MEMBER
  • 37 POSTS
This truck has been one heck of a work horse since I’ve had it, about six years. Then I was helping a friend move some things, and while we were on the road (driving some what uphill) it started loosing power and then, missing badly in the third cylinder. But without a load I can drive it and once the RPM’s get higher it’ll smooth out, then when they start dropping it starts missing again and popping. Any ideas?
Feb 1, 2019 at 12:17 AM
Advertisement
Avatar
ASEMASTER6371
  • ✓Experienced Mechanic
  • 52,796 POSTS
Good afternoon,

How long since a good tune-up?

https://www.2carpros.com/articles/engine-misfires-or-runs-rough

I would check the fuel pressure to be sure you have enough pressure.

https://www.2carpros.com/articles/how-to-check-fuel-system-pressure-and-regulator

A compression test should also be done.

https://www.2carpros.com/articles/how-to-test-engine-compression

Roy
Feb 1, 2019 at 12:47 AM
Avatar
TONYNEAL
  • MEMBER
  • 37 POSTS
Why would it smooth out on higher RPM's?
Feb 1, 2019 at 1:00 AM
Avatar
TONYNEAL
  • MEMBER
  • 37 POSTS
Compression test = negative,
Air test = negative
Checked coil = negative
Feb 1, 2019 at 1:07 AM
Avatar
ASEMASTER6371
  • ✓Experienced Mechanic
  • 52,796 POSTS
Negative? If you mean you did the tests, what were the results?

Roy
Feb 1, 2019 at 7:08 AM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle