2020 misfires when accelerating?

Yep, chances are the ignition coils needs replacement, or if you run the codes you can see which cylinder is failing and just replace that one. Here is how to run the codes to see which cylinder it is

https://www.youtube.com/watch?v=LBCpCWEFnTg

Here is another video that may help

https://www.youtube.com/watch?v=QTE8k06MzwQ

And of course this guide goes over all reasons for a misfire.

https://www.2carpros.com/articles/engine-misfires-or-runs-rough

Please go over these guides and get back to us. Ken

I have checked my ignition coils and nothing was wrong. I only got my low pressure fuel pump replaced not my high pressure. Do you think it is the high pressure instead?

Yes, it could be, do you have any codes?

I do not have any codes, it just misfires, but nothing shows up.

Sometimes it takes a while before the codes are set, can you read the cylinder misfire count on your scanner? Also does it misfire all the time or just when accelerating? Can I get a short video of what is going on?

It only misfires when accelerating. When it starts misfiring the gas just has no power and it just jitters, not going any faster. Sometimes it loses completely and the gas pedal stops working.

I am getting the high pressure replaced today, which could be the issue. Thanks for the help though.

Yep, high pressure pumps go out all the time so that can be it, usually it will have a trouble code for it so that part is strange but you never know. Also, I would remove the spark plugs and make sure one or more is not cracked, this will cause the issue you have described as well. Please let me know what happens.

They swapped two of the coils, since the code went off and it ran fine for a bit, but now it still kinda misfires when I hard accelerate onto the ramp. I will check the spark plugs again Thank you.

Yep, it sounds like you may have a cracked spark plug, let me know, Ken