I'm installing a kleinn model 6126 air Horn. Where is the existing horn located, and is it a negative circuit?
Jan 14, 2015 at 9:42 PM
2014 Dodge Ram again, Horn
2014 DODGE RAM
GRANDUDE50
- MEMBER
- 2 POSTS
Advertisement
JACOBANDNICKOLAS
- ✓ASE Certified Mechanic
- 110,194 POSTS
We only deal with OEM type repairs and direct fit parts.
Jan 15, 2015 at 5:17 AM
What does that have to do either question?
Jan 15, 2015 at 6:20 PM
JACOBANDNICKOLAS
- ✓ASE Certified Mechanic
- 110,194 POSTS
The horns have a path to ground all the time. The horns are actuated or controlled by a B+ output via a relay soldered to a printed circuit board in the power distribution center and is controlled by the body control module.
The horn is mounted and secured by one screw to the left upper fender load beam above the left front wheel opening.
The reason I said we only deal with direct fit parts is this. The system is designed to handle a specific amperage load. Via a relay, printed circuit board, the body control module... power is supplied. If there is an excessive draw on the system, problems will occur.
The horn is mounted and secured by one screw to the left upper fender load beam above the left front wheel opening.
The reason I said we only deal with direct fit parts is this. The system is designed to handle a specific amperage load. Via a relay, printed circuit board, the body control module... power is supplied. If there is an excessive draw on the system, problems will occur.
Jan 16, 2015 at 5:12 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.