Replace all plugs and coils and fuel injector car still has 4 misfire.
Feb 7, 2020 at 8:04 AM
Code p0304 02 4 misfire
2013 FORD EDGE
LYDIA WILLIAMS
- MEMBER
- 1 POST
Advertisement
ASEMASTER6371
- ✓ASE Certified Mechanic
- 52,796 POSTS
Good morning,
Did you check the fuel pressure?
Did you check the compression in number 4?
https://www.2carpros.com/articles/engine-misfires-or-runs-rough
https://www.2carpros.com/articles/how-to-test-engine-compression
Roy
Did you check the fuel pressure?
Did you check the compression in number 4?
https://www.2carpros.com/articles/engine-misfires-or-runs-rough
https://www.2carpros.com/articles/how-to-test-engine-compression
Roy
Images (Click to enlarge)
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Click here to log in and view diagram.
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Click here to log in and view diagram.
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Click here to log in and view diagram.
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Click here to log in and view diagram.
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Click here to log in and view diagram.
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Click here to log in and view diagram.
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Click here to log in and view diagram.
Feb 7, 2020 at 8:49 AM
BMDOUBLE
- ✓ASE Certified Mechanic
- 1,139 POSTS
These cars along with the Ford Flex have a common issue with the power-train control module (PCM). The PCM's coil drivers go bad and will sometimes melt the coil because the driver will stay stuck on. This is a possibility, but the basic tests noted above should be done first.
Feb 7, 2020 at 10:41 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.