outside driver's mirror?

2011 CHRYSLER TOWN AND COUNTRY
42,000 MILES • 6 CYL • FWD • AUTOMATIC
Avatar
BUCIDAC
  • MEMBER
  • 1 POST
I'm getting ready to replace the mirror on the driver's side. Do I need any special tools to remove the inside trim parts to get to the mounting bolt? Are there any resets that need to be done because of the blind spot sensor and auto dim headlight sensor?
Dec 16, 2013 at 3:00 PM
Advertisement
Avatar
DANNY L
  • ✓ASE Certified Mechanic
  • 5,648 POSTS
  • ASE Certified Mechanic
Hello, I'm Danny.

You will not need any special tools to replace. Just simply remove the access cover to gain access to the mirror bolts and wiring harness connector. There is no relearn process needed. I've attached 2 picture steps below. Hope this helps and thanks for using 2CarPros.
Images (Click to enlarge)
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Dec 24, 2020 at 8:57 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.