outside driver's mirror?

2011 CHRYSLER TOWN AND COUNTRY

42,000 MILES • 6 CYL • FWD • AUTOMATIC

BUCIDAC

MEMBER
1 POST
FOLLOW

I'm getting ready to replace the mirror on the driver's side. Do I need any special tools to remove the inside trim parts to get to the mounting bolt? Are there any resets that need to be done because of the blind spot sensor and auto dim headlight sensor?

Dec 16, 2013 at 3:00 PM

Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.

DANNY L

CAR REPAIR CONTRIBUTOR
5,648 POSTS

Hello, I'm Danny.

You will not need any special tools to replace. Just simply remove the access cover to gain access to the mirror bolts and wiring harness connector. There is no relearn process needed. I've attached 2 picture steps below. Hope this helps and thanks for using 2CarPros.

Images (Click to enlarge)

Dec 24, 2020 at 8:57 PM