Heater blower motor speed?

Tiny
FOOL
  • MEMBER
  • 2010 FORD ESCAPE
  • 2.5L
  • 4 CYL
  • 2WD
  • AUTOMATIC
  • 43,000 MILES
The blower does not work on settings 1and 2.
Tuesday, November 11th, 2014 AT 10:28 AM

1 Reply

Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,758 POSTS
Hi,

The most common cause of this problem is a bad blower motor resister. If it still works on high speed, this is the first thing I suspect.

Here are the directions for replacement. The attached picture correlates with the directions.

___________________________________

2010 Ford Truck Escape 2WD L4-2.5L
Blower Motor Resistor
Vehicle Heating and Air Conditioning Blower Motor Resistor Service and Repair Removal and Replacement Blower Motor Resistor
BLOWER MOTOR RESISTOR
412-01 Climate Control 2010 Escape, Mariner, Escape Hybrid, Mariner Hybrid
REMOVAL AND INSTALLATION
Blower Motor Resistor

pic 1

Item Part Number Description
1 †Blower motor resistor electrical connector (part of 19D887)
2 W701696 Blower motor resistor screw (2 required)
3 18591 Blower motor resistor
Removal and Installation

Lower the glove compartment.
Disconnect the blower motor resistor electrical connector.
Remove the 2 blower motor resistor screws.
To install, tighten to 3 Nm (27 lb-in).
Remove the blower motor resistor.
To install, reverse the removal procedure.

_____________________________

I hope this helps. Let me know if you have other questions.

Take care,
Joe
Was this
answer
helpful?
Yes
No
Friday, December 25th, 2020 AT 9:17 PM

Please login or register to post a reply.

Sponsored links