2010 CHEVROLET HHR
71,230 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
remove steering wheele to replace power steering assist motor unpulled all wires to steering wheele. install everything back car wan start or crank.tried reprograming the key still nothing and the security light want come on. what could be the problem?
Feb 12, 2013 at 10:28 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
GMTECH
  • CAR REPAIR CONTRIBUTOR
  • 537 POSTS
You must not have plugged the secuirty sensor back onto place. Did you replace the whold column or just the motor. You could have done the motor in place. Double check all your wiring.The sensor is at the ignition cylinder
Feb 13, 2013 at 3:46 PM
Advertisement