starting and vibrating

2009 SUZUKI ALTO

25,000 MILES • 4 CYL • FWD • MANUAL

JANMJUNIOR

MEMBER
1 POST
FOLLOW

I hv suzuki alto vxr assembled in pakistan, which is 1000cc with f10a soch engine mounted. When i go to early in the morning for start the car, as i ignited the key car starts but after 3 to 5 seconds engine off. on the next attempt engine misfire and don't starts only crancking after pushing the accelator pedal and clutch pedals it starts but as i push the accelator pedal its again stop, after it the engine starts but heavily vibrate the whole engine for a little time for engine in working temptratur. i hv no any manual for this car, n hv no some possible dignosis tools. plz me to fine out the problem of this.
thanks

Mar 21, 2011 at 3:08 PM

Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.

JACOBANDNICKOLAS

AUTOMOTIVE REPAIR CONTRIBUTOR
110,190 POSTS

Check fuel pump pressure. There are directions and a video on our home page under the DIY section. Next, check to make sure the idle air control valve is good.

I noticed that the vehicle is an 09 with only 25K on it. It should be under the manufacturer's warranty. For sure, any immisions components are covered at this point. Have you had a dealer check it? Most likely, the problem will be covered under your emissions warranty. Have a dealer look at it and let me know what you find.

Jun 21, 2011 at 3:49 AM