2009 Hyundai Accent transmission

2009 HYUNDAI ACCENT
1.5L • 4 CYL • FWD • AUTOMATIC
Avatar
KEVINBERG
  • MEMBER
  • 2 POSTS
i need to replace the thrust and cup bearing in between the third and fourth gear in the transmission but do not want to remove engine from car, how can i take the cover off without doing this?
May 10, 2015 at 6:40 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • ✓ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
To access the internals of the transmission, you have to remove the trans or engine to take it apart.
May 10, 2015 at 7:24 PM
Avatar
KEVINBERG
  • MEMBER
  • 2 POSTS
I would really prefer not to pull the eng. and trans., could I instead just unbolt the last 2 motor mounts to slide the engine over to the passenger side to get enough room for the cover to come off?
May 11, 2015 at 5:02 AM
Avatar
JACOBANDNICKOLAS
  • ✓ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
It may work, but I question it. Measure things to see if there is enough room.
May 11, 2015 at 8:30 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.