2009 Dodge Truck Clutch fit

2009 DODGE TRUCK
110,000 MILES • 6.7L • 6 CYL • 4WD • MANUAL
Avatar
TIMCOOKIE
  • MEMBER
  • 1 POST
6.7 cummins with 6 speed 2500 Ram
Replacing dual mass flywheel and clutch with solid clutch and flywheel from perfection. Flywheel seems to be pushing against plate on crank tightly. With tranny bolted. Tight flywheel will turn engine before bolts installed to crank plate. Had to loosen tranny bolts to align plate and flywheel bolts. Any ideas what's wrong?
Dec 4, 2014 at 6:31 AM
Advertisement
Avatar
BLACKOP555
  • ✓ASE Certified Mechanic
  • 10,386 POSTS
  • ASE Certified Mechanic
can you please reword that better? they flywheel is bolted to crank direct so it should be tight against crank. make sure you have proper flywheel and have the clutch disk installed with the right side against the flywheel and not against pressure plate, should be marked on disk.
Dec 4, 2014 at 6:31 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.