how do I reprogram the key fob on my 08 Saturn Sky.
Jun 30, 2011 at 1:39 PM
reseting key fob
2008 SATURN SKY
VENTURESCOTT
- MEMBER
- 2 POSTS
Advertisement
KHLOW2008
- ✓ASE Certified Mechanic
- 41,814 POSTS
Here are the procedures.
TRANSMITTER PROGRAMMING
Invalidate All
This procedure will erase all keyless entry transmitters from memory.
1. Install a scan tool.
2. Turn ON the ignition with the engine OFF.
3. With the scan tool, select Body.
4. Select Remote Control Door Lock Receiver (RCDLR).
5. Select Module Setup.
6. Select Program Key Fobs.
7. Select Invalidate All.
8. Follow the scan tool on screen instructions.
Next Available Slot
Incremental programming allows for a transmitter to be reprogrammed into the next available location without affecting the currently programmed transmitters. Previously programmed transmitters will not be erased during this procedure.
1. Install a scan tool.
2. Turn ON the ignition with the engine OFF.
3. With the scan tool, select Body.
4. Select Remote Control Door Lock Receiver (RCDLR).
5. Select Module Setup.
6. Select Program Key Fobs.
TRANSMITTER PROGRAMMING
Invalidate All
This procedure will erase all keyless entry transmitters from memory.
1. Install a scan tool.
2. Turn ON the ignition with the engine OFF.
3. With the scan tool, select Body.
4. Select Remote Control Door Lock Receiver (RCDLR).
5. Select Module Setup.
6. Select Program Key Fobs.
7. Select Invalidate All.
8. Follow the scan tool on screen instructions.
Next Available Slot
Incremental programming allows for a transmitter to be reprogrammed into the next available location without affecting the currently programmed transmitters. Previously programmed transmitters will not be erased during this procedure.
1. Install a scan tool.
2. Turn ON the ignition with the engine OFF.
3. With the scan tool, select Body.
4. Select Remote Control Door Lock Receiver (RCDLR).
5. Select Module Setup.
6. Select Program Key Fobs.
Jun 30, 2011 at 2:20 PM
where do I get a "scan tool"?
Jun 30, 2011 at 5:38 PM
SATURNTECH9
- ✓ASE Certified Mechanic
- 30,869 POSTS
Just to add to this one if the key fob was working with your car you can try reseting it by going by the car holding the lock and unlock buttons down at the same time for about ten seconds if it resets you will hear the car lock and unlock and the horn will honk.The scan tool you won't find anywhere then the dealer most likely it takes a tech2 scan tool with the correct software.If its a new remote and you need to program it a dealer is your best bet.
Jun 30, 2011 at 6:01 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.