peugoet 407sw keeps cutting out

2008 PEUGEOT 407
50,000 MILES • FWD • MANUAL
Avatar
DGRIER
  • MEMBER
  • 3 POSTS
nobody seems to know why my 407sw 2.0hdi keeps cutting out it only happens when i'm slowing down for lights or junctions i noticed today there is a orange dust all over the engine help!!
Feb 20, 2011 at 7:04 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
JACOBANDNICKOLAS
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 110,190 POSTS
I don't know where you are located, but orange dust is usually from dried out coolant. As far as the engine, check for vacuum leaks and check to make sure the IAC is working properly.
Feb 25, 2011 at 1:31 PM
Advertisement
Avatar
DGRIER
  • MEMBER
  • 3 POSTS
my knowledge of cars is limited what is the iac
Feb 26, 2011 at 2:13 PM
Avatar
JACOBANDNICKOLAS
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 110,190 POSTS
IAC stands for idle air control. It is a solenoid that is responsible for maintaining engine idle.
Feb 27, 2011 at 4:30 AM
Avatar
DGRIER
  • MEMBER
  • 3 POSTS
would you know where abouts it is located in the engine thanks for your help
Feb 27, 2011 at 9:16 AM
Avatar
JACOBANDNICKOLAS
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 110,190 POSTS
On the throttle body (where the carb would sit on an old car).
Feb 28, 2011 at 1:41 AM