Car is LS460 - How do you reset oil change reminder after oil changed and what does a triangle with a ! in it means on dash display?
Nov 28, 2012 at 12:40 PM
2008 LEXUS LS
ANONYMOUS
- MEMBER
- 1 POST
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
The symbol indicaates a fault with the brake stability control. It could be others and you need to get it checked.
ENGINE OIL REPLACEMENT REMINDER RESET - PROCEDURE 7
NOTE:
Vehicle is equipped with electronic ignition key. Key should be on your person. Engine switch mode can be changed by pressing ENGINE START/STOP button (1-OFF; 2-ACC; 3-IG-ON) without depressing brake pedal (A/T) or clutch pedal (M/T). Depressing brake or clutch pedal and pressing engine switch will start the engine (engine switch indicator turns Green).
To reset MAINT reminder light after engine oil change:
1. Start engine (or activate the Hybrid system). Switch the odometer display to TRIP A while the engine is running.
2. Turn the "ENGINE START STOP" switch to OFF.
3. Turn the "ENGINE START STOP" switch to IGNITION ON mode with trip meter reset button held down.
NOTE:
DO NOT start engine, otherwise the reset mode will be cancelled.
4. Press and hold the button until the multi-information display indicates that the reset is complete.
ENGINE OIL REPLACEMENT REMINDER RESET - PROCEDURE 7
NOTE:
Vehicle is equipped with electronic ignition key. Key should be on your person. Engine switch mode can be changed by pressing ENGINE START/STOP button (1-OFF; 2-ACC; 3-IG-ON) without depressing brake pedal (A/T) or clutch pedal (M/T). Depressing brake or clutch pedal and pressing engine switch will start the engine (engine switch indicator turns Green).
To reset MAINT reminder light after engine oil change:
1. Start engine (or activate the Hybrid system). Switch the odometer display to TRIP A while the engine is running.
2. Turn the "ENGINE START STOP" switch to OFF.
3. Turn the "ENGINE START STOP" switch to IGNITION ON mode with trip meter reset button held down.
NOTE:
DO NOT start engine, otherwise the reset mode will be cancelled.
4. Press and hold the button until the multi-information display indicates that the reset is complete.
Nov 28, 2012 at 1:07 PM
Advertisement