How do you replace brake switch on 2008 KIA Sportage
Feb 9, 2013 at 3:03 PM
2008 KIA SPORTAGE
ANONYMOUS
- MEMBER
- 1 POST
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
BRAKE SWITCH CLEARANCE
Screw in the brake switch until its plunger is fully depressed (threaded end (A) touching the pad (B) on the pedal arm) then adjust the switch 3/4 turn to until clearance between the brake switch connector. Make sure
that the brake lights go off when the pedal is released.
Fig. 7: Checking Clearance
Courtesy of KIA MOTORS AMERICA, INC.
Screw in the brake switch until its plunger is fully depressed (threaded end (A) touching the pad (B) on the pedal arm) then adjust the switch 3/4 turn to until clearance between the brake switch connector. Make sure
that the brake lights go off when the pedal is released.
Fig. 7: Checking Clearance
Courtesy of KIA MOTORS AMERICA, INC.
Image (Click to enlarge)
Feb 9, 2013 at 4:44 PM
Advertisement