Engine Hot A/C Off

2008 GMC ACADIA
100,000 MILES • 3.6L • 6 CYL • AWD • AUTOMATIC
Avatar
TAHIRSHAH
  • MEMBER
  • 1 POST
Hi,
While driving in the morning, outside 9 degree, after about 10 minutes I received a message that 'Engine Hot A/C Off'. It happened after turning on seat heater for about 2 minutes. I have driven car for about 130km then engine service light also turned on.
Appreciate if you could please advise.
Dec 27, 2013 at 2:18 AM
Advertisement
Avatar
WRENCHTECH
  • Experienced Mechanic
  • 20,761 POSTS
It's telling you the engine is overheating and you need to shut it off. If the engine isn't over heating it may be bad coolant sensor causing this. I would start by scanning the computer for codes to see what it is recording as a failure, this will give a starting point

See the guides below

https://www.2carpros.com/trouble_codes/obd2

https://www.2carpros.com/articles/coolant-temperature-sensor-cts-replacement
Dec 27, 2013 at 3:18 AM
Avatar
JACOBANDNICKOLAS
  • Experienced Mechanic
  • 110,240 POSTS
Hi,

It seems as though the engine is overheating, but the idea that it happens when you turn the seat heater on is odd. What I suggest is to have the CAN bus system scanned. CAN stands for computer area network. If you do this, it should indicate if there is a break down in communication in the network and specifically where it is happening.

Here is a video showing how it's done:

https://youtu.be/InIlnsjOVFA

This is what I suggest. If you find it isn't related to the seat heater, let me know. Also, confirm coolant is full and clean.

Let me know what you find.

Joe
Aug 12, 2020 at 3:49 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.