motor no arranca ford f350 2008 6.4 diesel XLT

2008 FORD F-350
23,500 MILES
Avatar
CATS0439
  • MEMBER
  • 2 POSTS
I have a ford F-350 2008 XLT 6.4 Diesel 8cil, whose problem is bootable. removal was done to seal a turbo oil leak by one of the hallmarks of the bottom, after the completion of assembly was checked if the leak had been corrected, apparently being operational. after 20 minutes remain on the engine, turn off this suddenly, and no longer wants arranacar again. syu appreciate support
Jun 18, 2012 at 3:15 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
ASEMASTER6371
  • CAR REPAIR CONTRIBUTOR
  • 52,796 POSTS
did you have the high pressure pump checked?? make sure the oil level is good.

Roy
Jun 18, 2012 at 11:08 PM
Advertisement
Avatar
CATS0439
  • MEMBER
  • 2 POSTS
the oil level is fine, but when performing verification of the fuel pressure, this is 35.23 KPa, arraja PCV 42% and 41% CVV, also check for any leaks but nothing. will be high pressure pump fuel (fuel system common rail)
Jun 19, 2012 at 2:51 AM