How to replace a thermostat. Housing seal gasket on a Dodge charger 2008 engine size 2.7
Mar 16, 2013 at 2:22 PM
2008 Dodge Charger Replace Thermostat Housing Seal Gasket On Engine Size 2 7
ANONYMOUS
- MEMBER
- 1 POST
Advertisement
Hello,
Here is a guide to show you what you are in for when replacing a thermostat.
https://www.2carpros.com/articles/replace-thermostat
1. Disconnect negative cable.
WARNING: Do not remove pressure cap with the system hot and under pressure because serious burns from coolant can occur.
2. Drain cooling system See: Service and Repair.
3. Remove radiator lower hose from thermostat housing (1).
4. Remove nuts (3) from heater tube flange studs.
5. Loosen starter bolt at heater tube bracket.
6. Pull heater tube out of thermostat housing and position out of the way.
7. Remove bolt (3) and two studs.
Here are some diagrams for your car.
Please let us know happens so it will help others.
Best, Ken
Here is a guide to show you what you are in for when replacing a thermostat.
https://www.2carpros.com/articles/replace-thermostat
1. Disconnect negative cable.
WARNING: Do not remove pressure cap with the system hot and under pressure because serious burns from coolant can occur.
2. Drain cooling system See: Service and Repair.
3. Remove radiator lower hose from thermostat housing (1).
4. Remove nuts (3) from heater tube flange studs.
5. Loosen starter bolt at heater tube bracket.
6. Pull heater tube out of thermostat housing and position out of the way.
7. Remove bolt (3) and two studs.
Here are some diagrams for your car.
Please let us know happens so it will help others.
Best, Ken
Images (Click to enlarge)
Dec 15, 2016 at 3:04 AM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement
parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.