2008 Dodge Avenger code p2016

2008 DODGE AVENGER
200,000 MILES • 2.4L • 4 CYL • 2WD • AUTOMATIC
Avatar
AIMANRRR
  • MEMBER
  • 1 POST
I have dodge avenger 2008 and this code is showing P2016 and I can’t remove check engine light
I have changed the following and I can’t go off:
1. I have changed the sensor.
2. I have changed the manifold runner control

Still the check engine light is on,
I don’t know how to solve the issue
I have put on my dodge air intake system (K&N)
Mar 23, 2015 at 10:24 PM
Advertisement
Avatar
CARADIODOC
  • ✓ASE Certified Mechanic
  • 34,321 POSTS
  • ASE Certified Mechanic
The sensor is a good suspect but it's important to understand that fault codes never say to replace parts or that one is bad. They only indicate the circuit or system that needs further diagnosis, or the unacceptable operating condition. You also have to check for wiring problems and pins bent over in the connectors. The next step is to connect a scanner to view live data and see what the sensor is reporting. Next is to take voltage readings at the sensor and compare the two.
Mar 23, 2015 at 11:02 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.