What is the proper compression for my 08 chevy hd duramax 6.6 liter 4x4?

2008 CHEVROLET SILVERADO
89,000 MILES
Avatar
CREASOLEPOLE
  • MEMBER
  • 1 POST
The dealership told me that my compression was low and that they needed to check the rods and if they are not bent then i have to replace the entire engine.
Mar 13, 2012 at 9:03 PM
Advertisement
Avatar
HMAC300
  • ✓ASE Certified Mechanic
  • 48,601 POSTS
  • ASE Certified Mechanic
400Lbs would be good for that vehicle.but all cylinders should read withint 70% of highest cylinder reading. No cylinder shold read below 100 lbs. But on a diesel that would be a really sick puppy if it were that low. Normally rods get bent do to hydraulicing. meaning a liquid getting in the cylinder.
Mar 13, 2012 at 10:48 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.