During brake service, I removed the brake rotors to be machined.These rotors do not come off easily like most. The wheel speed sensor is pressed onto the unit bearing, like a wheel seal. I tried to remove the sensor vs.un-plugging the sensor and taking it out with the unit bearing. This was not a good idea and now my ABS light is on.I put an ohm meter on both the LH and RH sides and the RF is open. I located the sensor locally at a Napa auto parts for about $60.I would like to not screw up the new part
and would appreciate the proper method to R/R.
The truck is a 2 whl. drive -4 cyl. A/T -it is a LT model-ext. cab
and would appreciate the proper method to R/R.
The truck is a 2 whl. drive -4 cyl. A/T -it is a LT model-ext. cab
Mar 13, 2012 at 2:54 AM