Front brakes what is everything I need for a complete brake job

Hi,

Replacing brakes isn't too hard to do. First, here is a link that explains in general how it's done. You can use these as a guide:

https://www.2carpros.com/articles/how-to-replace-front-brake-pads-and-rotors-fwd

Here are the directions specific to your vehicle. The attached pics correlate with the directions.

Removing

Note: When removing, mark brake pads that will be used again. Install in the same position, otherwise braking effect will be uneven!

- Remove wheels.
- Using screwdriver, pry off brake pad retaining spring from brake caliper -arrow- and remove.

Separate the connector -1- for brake pad wear indicator.

Remove caps -arrows-.

Loosen both guide pins -arrows- and remove from brake caliper.

Remove brake caliper and secure with wire so that the weight of the brake caliper does not burden or damage the brake hose.
- Remove brake pad from brake caliper or from brake carrier.

Cleaning:

Warning! Do not blow brake system using compressed air, the dust produced is harmful to health!

- Thoroughly clean contact surfaces for brake pads at brake carrier, remove corrosion.
- Clean brake caliper, especially the adhesive surface for the brake pad, it must be free of residual adhesive and grease.

Note: Use only appropriate solvents for cleaning brake caliper.

Installing

Note: Before pressing piston into cylinder using piston resetting tool, brake fluid must be extracted from brake fluid reservoir. Otherwise, especially if reservoir has been topped off, fluid will overflow and cause damage.

- Press piston back.

Remove protective foil on backing plate of outer brake pad.
- Install outer brake pad on brake carrier.
- Insert inner brake pad with retaining spring in brake caliper (piston).

When installing brake caliper, make sure that brake pad is not affixed to brake caliper before the correct installation position has been reached.

Do not damage the adhesion surface.

- Tighten brake caliper to brake carrier using both guide pins.

Install both protective caps.
- Install retaining spring in brake caliper.
- Connect brake pad wear indicator connector.
- Install wheels.

Note:
After replacing brake pads and before moving vehicle, always depress brake pedal several times firmly to properly seat brake pads in their normal operating position.
Check brake fluid level after replacing brake pad.

Check out the diagrams (Below). Please let us know if you need anything else to get the problem fixed.