shudder when accelerating engine warning lamp flashing

2007 VOLKSWAGEN GOLF
60,000 MILES
Avatar
V D S
  • MEMBER
  • 1 POST
I have a 2007 vw golf 1.4l petrol tsi manual transmission wit a problem av asked quite few people and only bought it last September and is under 1 yrs warranty. from bout 2/3 months after i bought car it has 'shuddered' when accelerating whit engine warning lamp flashing and wen slow down and accelerate up again very quickly. Garage where purchased car nothing has shown on diagnostic and has changed fuel filter (ref vw dealer) and seemed to be fine after one week started same again. ran diagnostic showed 1st cylinder pack misfire and changed the 1st cylinder coil pack and was having more power etc back 2 normal for bout 6 weeks den started again. nothing showing on diagnostic twice den showed oil pressure switch! Great site :-)
Feb 23, 2012 at 10:55 AM
Advertisement
Avatar
KHLOW2008
  • ASE Certified Mechanic
  • 41,814 POSTS
  • ASE Certified Mechanic
Since vehicle is still under warranty, you should get back to the people responsible.

After each repair, the problem was resolved and comes back after some time, they could be different problems and if diagnostics do not come up with anything, the best thing is to plug in a scan tool and go for a test drive to get the problem to occur. You would then be able to capture the freeze frame data and note which componrent or circuit is faulty.

As the problem is intermittent, it could be due to a loose or contaminated wire connector somewhere and you need to find the circuit that is causing the problem to proceed with rectification.


Feb 23, 2012 at 11:36 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.