Serpintine belt

REMOVAL
1. REMOVE V-BANK COVER SUB-ASSEMBLY
2. REMOVE NO. 1 ENGINE UNDER COVER
3. REMOVE FAN AND GENERATOR V BELT
a. While turning the belt tensioner counterclockwise, align the service hole for the belt tensioner and the belt tensioner fixing position, and then insert a bar of ø 5 mm (0.197 in.) into the service hole to fix the belt tensioner in place.
a.
Fig. 10: Turning Belt Tensioner Counterclockwise

HINT:
The pulley bolt for the belt tensioner has a left-hand thread.

b. Remove the V belt.


INSTALLATION

1. INSTALL FAN AND GENERATOR V BELT

a. Set the V belt onto every part.
Fig. 11: View Of Belt And Pulley

b. While turning the belt tensioner counterclockwise, remove the pin.
NOTE:
Make sure that the V belt is properly set to each pulley.

c. After installing the belt, check that it fits properly in the ribbed grooves.

HINT: Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.

2. INSTALL NO. 1 ENGINE UNDER COVER
3. INSTALL V-BANK COVER SUB-ASSEMBLY

© 2008 Mitchell Repair Information Co., LLC.