2007 Suzuki Reno clutch

2007 SUZUKI RENO
116,000 MILES • 2.2L • 4 CYL • 2WD • MANUAL
Avatar
LILVAL
  • MEMBER
  • 2 POSTS
was stopped at a red light, tried to to pull out from red light, clutch pedal was stuck on floor, car is stuck in gear, can physically raise clutch pedal, is the problem the master cylinder for clutch or is the clutch out??
Mar 18, 2015 at 2:57 PM
Advertisement
Avatar
CATAFINA
  • ✓ASE Certified Mechanic
  • 167 POSTS
  • ASE Certified Mechanic
Start by checking the clutch master cylinder and the slave
Mar 18, 2015 at 3:53 PM
Avatar
HMAC300
  • ✓ASE Certified Mechanic
  • 48,601 POSTS
  • ASE Certified Mechanic
if it stuck to floor I'd say it would be the clutch because if you let off the pressure from pedal the pressure plate would force the release bearing out. try to shift it with engine off if it shifts then it's probably the clutch also look to see if rod on slave cylinder is fully extended.
Mar 18, 2015 at 4:00 PM
Avatar
LILVAL
  • MEMBER
  • 2 POSTS
Where is the master cylinder located for clutch??
Mar 18, 2015 at 8:34 PM
Avatar
HMAC300
  • ✓ASE Certified Mechanic
  • 48,601 POSTS
  • ASE Certified Mechanic
we dont' have apic of the master cylinder look on firewall. below reservoir. check to make sure it'snot a linkage problem
Mar 19, 2015 at 5:43 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.