How do you remove the battery on a 2007 Lincoln Navigator?
Nov 18, 2012 at 12:26 AM
2007 Lincoln Navigator You Remove Battery On Navigator
2007 LINCOLN NAVIGATOR
ANONYMOUS
- MEMBER
- 1 POST
Advertisement
ASEMASTER6371
- ✓ASE Certified Mechanic
- 52,796 POSTS
Removal and Installation
Disconnect the battery cables.
Loosen and remove the battery hold-down bolt and clamp.
To install, tighten to 9 Nm (80 lb-in) .
WARNING: When lifting a battery, excessive pressure on the end walls could cause acid to leak out through the vent caps, resulting in personal injury, or damage to the vehicle or battery. Lift with a battery carrier. Failure to follow these instructions may result in personal injury.
Remove the battery and the heat shield.
To install, reverse the removal procedure.
Disconnect the battery cables.
Loosen and remove the battery hold-down bolt and clamp.
To install, tighten to 9 Nm (80 lb-in) .
WARNING: When lifting a battery, excessive pressure on the end walls could cause acid to leak out through the vent caps, resulting in personal injury, or damage to the vehicle or battery. Lift with a battery carrier. Failure to follow these instructions may result in personal injury.
Remove the battery and the heat shield.
To install, reverse the removal procedure.
Nov 18, 2012 at 2:24 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.