2007 Jeep Wrangler Cooling system

120,000 MILES • 0.5L • 6 CYL • 4WD • AUTOMATIC
Avatar
BSENECA
  • MEMBER
  • 11 POSTS
My jeep is running hot. I changed the thermostat and water pump and did the whole heater core flushing system. And when I turn on the heater I get condensation coming through the vents. Could the fan be the problem if it doesn't come on once it starts to run hot?
Jul 8, 2015 at 4:06 AM
Advertisement
Avatar
HMAC300
  • ✓Experienced Mechanic
  • 48,601 POSTS
it cold be the fan check items in pic to see if they are good and check for cold spots on radiator when hot if you find any then the rad is bad. also have it pressure checked
Jul 8, 2015 at 5:20 AM
Avatar
HMAC300
  • ✓Experienced Mechanic
  • 48,601 POSTS
forgot pic
Jul 8, 2015 at 5:21 AM
Avatar
BSENECA
  • MEMBER
  • 11 POSTS
Ok I checked the fuses, all good. Also I changed the radiator a few months ago. The only thing I haven't changed is the heater core. Would the heater core being bad cause the problems I listed and could I bypass the heater core by disconnecting it perhaps?
Jul 8, 2015 at 6:10 AM
Avatar
HMAC300
  • ✓Experienced Mechanic
  • 48,601 POSTS
the condensation could be the heater core or the drain for a/c plugged so try unplugging that you'll have to look under the car. or at bottom of firewall it's item 1 in pic run a wire through it to see if it's plugged. if not plugged then bypass heater core. but it's not causing your overheating. have it pressure checked for internal leaks like a head gasket.
Jul 8, 2015 at 7:55 AM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle