2007 Jeep Wrangler clutch

2007 JEEP WRANGLER
118,000 MILES
Avatar
BBIALAS
  • MEMBER
  • 1 POST
6 mos ago had the clutch rebuilt and new Throw Out Bearing. 3 weeks ago the clutch started to deteriorate and get closer to the floor over a 2-3 day period. Next morning, no clutch at all. Mechanic said a rear brake caliper had broken and leaked fluid, thus impacting the clutch since the brake and clutch system share same reservoir. They rebuilt caliper, and then pads and rotors in front and pads in back. Re-filled fluids and and all was good. 2 weeks later, no clutch again seemingly out of nowhere. Fluids were a bit low and refilled but had no impact. Thoughts?
Aug 11, 2013 at 9:59 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
HMAC300
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 48,601 POSTS
check clutch adjustment and for leaks in hydraulic system
Aug 11, 2013 at 10:25 AM
Advertisement
Avatar
MADMIKE1735
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 951 POSTS
rebleed your slave cylinder.... has air in it....
Sep 14, 2013 at 7:26 PM