Hole in Top of Battery

2007 JEEP LIBERTY
Avatar
MTHALE
  • MEMBER
  • 2 POSTS
Hi, my mother and i did something really stupid. We were trying to jump start a car, and I believe she mixed up the cables. The red clamp melted and the wire came out and was really hot, and it burned a small hole (pinky size) in the top of the battery case. It does not seem to have done any damage inside; however, I'm worried about fumes or poisonous air coming in through the front of the car. Any help would be appreciated.
Jun 25, 2011 at 6:02 PM
Advertisement
Avatar
CARADIODOC
  • ASE Certified Mechanic
  • 34,321 POSTS
  • ASE Certified Mechanic
Batteries give off hydrogen which is explosive. There is a product that makes sealing that hole real easy. Head to the Chrysler dealer's parts department and ask for a tube of silicone gasket sealer but it has to be the gray stuff, not the black. Sand the area around the hole to remove the shiny surface, wipe it clean, then coat and cover the area with about a 1/8" thick layer. It will set up in 20 minutes and get hard in an hour or two.

I used this to patch a hole in the bottom of a new battery that had been dropped, and it is still holding today after Ma hit a piece of metal on the highway with my '88 Grand Caravan and put a 2" x 3" hole near the bottom of the gas tank over 20 years ago. You won't need the whole tube of sealer, and it will get hard in the tube if you don't use it in a few months, so you might ask one of the mechanics if they have an almost used-up tube that you can have.
Jun 25, 2011 at 6:53 PM
Avatar
MTHALE
  • MEMBER
  • 2 POSTS
thanks for the help!!
Jun 27, 2011 at 7:32 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.